5 Tips on Maintaining Your Steam Shower

Steam showers are pricier than your average shower, but considering all the benefits, we’re sure you’ll agree that it’s worth the investment. Bearing in mind how much the cost is, as much as possible we would want to maintain the state of our newly installed steam shower as it is. The trick is to be on top of things and not wait until the damage becomes hard to fix, and to do that, follow the tips below:

Steam Shower/ Whirlpool Bathtub DA328F3-1 59.1″x32″x87″

Weak Steam Output
After about 20 showers its good practice to clean the steam generator
Fill the tank with between 5 to 10 grams of citric acid diluted with about 1.5 liters of warm water.
Let it set for 12 hours before turning it on to heat the water. This will vaporize the citric acid.
The steam generator will have a manual drain valve. This valve should be drained approximately every 2 months. You may have to remove any large clumps by hand. Source: Bathroomz

Inspecting for Tightness of Seals and Joints
Silicone seals, water supply joints, valves, and nozzles should be checked at least once a year. If the silicone seals are loose, replace them. Sealing the doors and walls is quite easy. Nozzles, joints, and drainage systems can be tightened or repaired using the most basic plumbing skills. Source: DoItYourself

It’s Worth It to Squeegee
Water can leave behind minerals that create a whitish haze over glass doors and tile. The longer the minerals sit, the harder they are to remove. So a quick squeegee after the last shower of the day will make cleaning easier in the long run. Source: HGTV

A Natural Alternative
A mixture of baking soda and water makes a scum-fighting scrub that many experts swear by. Measurements for the mixture will vary depending on how much you need. To get started, try using a half-cup of baking soda, and then add water as needed to make a thick paste. Using a nonabrasive sponge, scrub the glass and rinse it with vinegar. Source: Houzz

Maintaining Steam
Hot, damp areas are perfect incubators for mold and mildew. After using your steam shower, open the door to dry out your bathroom, and run the exhaust fan to suck out the steam.
Every few months, flush the unit to get rid of calcium deposits. Source: Houselogic

Contact:
Eago Parts
Phone: Toll Free 1-888-556-1912
Calgary, Alberta
Email: info@eagoparts.com

2 Comments
  1. What should I flush a steam shower with?

    • We dont recommend putting anything in the steam generator as that can leave a residue on the heating elements and cause other problems. If your steamer has not be serviced in awhile you may want to remove the bottom off of the steam generator and physically remove any calcium deposits from inside the steamer.

Leave a reply

EAGO Parts.Com
Logo