3 Tips for Cleaning your Shower Properly

To clean your shower properly, you must have the right tools, products and techniques. In this article we’ll discuss some tips for cleaning your shower properly, including: removing mildew, cleaning your shower curtain and clearing out the drain.

Image Source: Flickr
Image Source: Flickr

Below are 3 tips for cleaning your shower properly:

Removing Mildew
Before you grab your favorite tub-and-tile spray cleaner, ventilate the room by opening a window or at least the door. Then work on the shower in three vertical sections — this will cut down on fumes and prevent the cleaner from drying before you wipe it. Spray the first section, covering both tile and tub, and give it a few minutes to penetrate (use the time to go get a cup for the next step). Now, spray the second section, and let it soak while you clean the first. With a wet scrubber sponge (i.e., one with a no-scratch scouring pad), wipe down the first area, using wide strokes to cover the most surface in the least time; rinse the sponge. Fill your cup with water and rinse the cleaned area. When the first section is done, spray the third section, then wipe and rinse the second, followed by the third. For any remaining grout stains, mix up one part bleach and two parts water in a spray bottle. Let it soak in for a few minutes. Turn on the shower for a minute so it can self-rinse, and give any outside-of-the-stream spots a quick splash with your cup. Source: GoodHousekeeping

Cleaning your Shower Curtain
Take it from the top: Pour an ample amount of white vinegar into a plastic grocery bag (enough to fully submerge the showerhead nozzle) and tie it in place for an overnight soaking. Remove it in the morning and run the water to rinse. Give plastic shower curtains and liners a spin in the washing machine with your regular detergent and a few old towels, which act as scrubbers to help get rid of soap scum and mildew. Rehang to dry. For shower doors, make a paste by adding a few drops of distilled white vinegar to a cup of baking soda; apply it directly to the door (it’s nice and thick, so it will stick). Let sit for an hour, then rub with a microfiber cloth. Rinse and buff dry with a fresh, dry microfiber cloth. The tub is less of an issue—a weekly scrubbing is usually enough. But for extra gleam, fill it with hot water, then drain. Apply a bathroom cleaner and let sit for 15 minutes before scrubbing.
Why: Besides the soap-scum issue, there’s the showerhead, which can harborMycobacterium avium, a pathogen linked to pulmonary disease. Gerba says that turning on a neglected shower can send millions of germs straight into your lungs.
Best practices: Wipe condensation from all surfaces after showering, and leave the window open for one hour a day to lower the room’s humidity level. Source: RealSimple

Clearing Out the Drain
This is quite possibly the worst part of the process, especially if you have long hair. Grab a garbage can or a plastic bag. Then unscrew the cap on your drain or just reach in, depending on the style of your drain. Using a large crochet hook or clip clothespin or (if you must) your fingers, yank the hair out and quickly throw it away. Yuck! Keep pulling the hair out until the drain is clear. Better yet buy a Zip-It drain cleaning tool. Zip-It is a long plastic strip with teeth that get hairs stuck deep in the drain out. You may want to wear rubber gloves for this part, particularly if you share the shower with other people. There are just some hairs you don’t want to touch! Source: wikiHow

 

Contact:
Eago Parts
Phone: Toll Free 1-888-556-1912
Calgary, Alberta
Email: info@eagoparts.com

Leave a Reply

Your email address will not be published.