When you conserve water at home you’re not just saving the environment, but you’re also saving some money. Try these tips and see how much you can lower your bill each month.
Install a low-flow showerhead
It may cost you some money up front, but your water conservation efforts will save you money down the road. Conventional showerheads flow at 5 gallons per minute or more, whereas low-flow showerheads typically flow at 2.5 gallons per minute (or less!). Source: Gracelinks
Put plastic bottles or float booster in your toilet tank
To cut down on water waste, put an inch or two of sand or pebbles inside each of two plastic bottles to weigh them down. Fill the bottles with water, screw the lids on, and put them in your toilet tank, safely away from the operating mechanisms. Or, buy an inexpensive tank bank or float booster. This may save ten or more gallons of water per day.
Be sure at least 3 gallons of water remain in the tank so it will flush properly. If there is not enough water to get a proper flush, users will hold the lever down too long or do multiple flushes to get rid of waste. Two flushings at 1.4 gallons is worse than a single 2.0 gallon flush. A better suggestion would be to buy an adjustable toilet flapper that allow for adjustment of their per flush use. Then the user can adjust the flush rate to the minimum per flush setting that achieves a single good flush each time. Source: EarthEasy
Get or create a dual-flush toilet
This is basically a toilet that flushes a smaller amount of water for when you pee and more water for pooping, thereby saving water. Use the half flush button with a dual-flush toilet. Source: WikiHow
We offer top-of-the-line bathroom fixtures that you can use to replace the leaky ones in your home. Contact us!
Phone: Toll Free 1-888-556-1912